recentposts

Change MAC Address in Backtrack 5 R3

A Media Access Control address or MAC address is a unique identifier assigned to network interfaces. This uses for communications when connected to the network. Although MAC addresses is a unique identifier of network adapter, we can change it. In Backtrack 5 R3 there is a tool to change MAC address, it's called macchanger. But remember, the MAC address has a rule of notation so you can change it randomly.
Before you change the MAC address you must turn off the network interface. Open your terminal and run this command
ifconfig eth0 down

eth0 is a network interface (LAN), if you want change MAC address of wireless interface you can change eth0 with wlan0

Then change the MAC address
macchanger --mac xx:xx:xx:xx:xx:xx eth0

After that, turn on the network adapter.
ifcofig eth0 up



That's all. You can check your MAC address with ifconfig -a

5 Responses to "Change MAC Address in Backtrack 5 R3"

  1. ifconfig mon0 down
    macchanger -m 11:11:11:11:11:11 mon0
    ifconfig mon0 up

    ReplyDelete
    Replies
    1. Actually i am currently using Windows XP.operating system.What in case of Windows XP?

      Thanks
      Silvester Norman

      Change Mac Address

      Delete
  2. The information provided is not enough kindly write the steps to follow to change my MAC address .
    Thanks for sharing an alternative method to change MAC address .

    Change Mac Address

    Regards
    Silvester Norman

    ReplyDelete
  3. This method not always get results - try other methods. Some network adapters doesn't allow to change MAC.

    Thanks
    Silvester Norman

    Change Mac Address

    ReplyDelete
  4.  Knowledge giving Article! I appreciate you. I completely agree with you. If we talk about current scenario then it is must be update. I enjoyed reading. I would like to visit more for more queries.
    mac address

    ReplyDelete